
1) Copy UGDEV.prefs into $USERPROFILE directory
2) In Vulcan using the supplied data as the current working directory
3) Open ugdesign.dgd.isis and load layer ZONES
4) Right click on one of the points and select label->Point sequence, all points.
5) Run Underground->Development->Automatic Ramp
6) Under the "Specification Definition..." node ensure that ug.ros specification is selected
7) Click "Apply and Run"
8) Change the indicate mode to "Snap To Points"
9) Snap to the point 1 for the start point
10) Snap to the point 5 for the end point
11) Now snap to point 2 for the first fixed point
12) Now select point 3 followed by point 4
13) Right Click and select "Retain Current"
14) Notice that the ramp includes all of the selected "fixed points" and that the ramp was lengthened to ensure that the maximum grade was not violated.
